logo
banner banner
Blog Details
Created with Pixso. Home Created with Pixso. Blog Created with Pixso.

FFC Cable Buying Guide: How to Specify, Compare, and Source Flexible Flat Cables

FFC Cable Buying Guide: How to Specify, Compare, and Source Flexible Flat Cables

2026-11-19

1. What you are actually buying

An FFC is built in five layers, and every layer is a purchasing decision:

Layer Typical material What it controls What to watch
Conductor Tinned copper foil, 0.035–0.1 mm Current capacity, bend life Copper thickness vs. bend radius
Insulation PET (polyester) film Dielectric strength, temperature PET is rated to roughly 85 °C class, not 125 °C
Bond Adhesive / heat-lamination Peel strength, outgassing Adhesive bleed at the cut edge
Stiffener PET or PI tape, acetate cloth Insertion durability, contact force Peel-off is the #1 field failure
Contact finish Tin, nickel, nickel + gold Contact resistance, mating cycles, shelf life Gold vs. tin storage life differs sharply

Because the conductors are parallel and fixed, an FFC can only do point-to-point, 1:1 connections. It cannot branch, cannot be routed around an obstacle, and cannot have components soldered onto it. If your design needs any of those, you want an FPC, not an FFC — see the comparison in section 5.


2. The nine-parameter spec sheet

This is the table to fill in before you send an RFQ. Every row changes either price, lead time, or yield.

banner
Blog Details
Created with Pixso. Home Created with Pixso. Blog Created with Pixso.

FFC Cable Buying Guide: How to Specify, Compare, and Source Flexible Flat Cables

FFC Cable Buying Guide: How to Specify, Compare, and Source Flexible Flat Cables

2026-11-19

1. What you are actually buying

An FFC is built in five layers, and every layer is a purchasing decision:

# Parameter Common options Why it matters
1 Pitch 0.5 mm, 0.8 mm, 1.0 mm, 1.25 mm, 2.54 mm Sets connector family and maximum pin density
2 Pin count 4–50 pin typical; 68 pin and above on request Drives width, and connector availability
Layer Typical material What it controls What to watch
Conductor Tinned copper foil, 0.035–0.1 mm Current capacity, bend life Copper thickness vs. bend radius
Insulation PET (polyester) film Dielectric strength, temperature PET is rated to roughly 85 °C class, not 125 °C
Bond Adhesive / heat-lamination Peel strength, outgassing Adhesive bleed at the cut edge
Stiffener PET or PI tape, acetate cloth Insertion durability, contact force Peel-off is the #1 field failure
Contact finish Tin, nickel, nickel + gold Contact resistance, mating cycles, shelf life Gold vs. tin storage life differs sharply

Because the conductors are parallel and fixed, an FFC can only do point-to-point, 1:1 connections. It cannot branch, cannot be routed around an obstacle, and cannot have components soldered onto it. If your design needs any of those, you want an FPC, not an FFC — see the comparison in section 5.


2. The nine-parameter spec sheet

This is the table to fill in before you send an RFQ. Every row changes either price, lead time, or yield.

# Parameter Common options Why it matters
1 Pitch 0.5 mm, 0.8 mm, 1.0 mm, 1.25 mm, 2.54 mm Sets connector family and maximum pin density
2 Pin count 4–50 pin typical; 68 pin and above on request Drives width, and connector availability